Services · North Vancouver
Sump Pump Systems in North Vancouver
Sump systems move collected groundwater out of the home when gravity alone cannot keep up with hillside runoff or a high water table. On rainy-slope properties, a sump that never rests is often a symptom of upstream drainage issues - we check both rather than only swapping a pump.
Who this is for
- Homes with existing drains that need reliable powered discharge
- Basements where gravity outlets are unavailable or overloaded
- Owners seeing constant sump cycling during and after storms
- Projects pairing interior drainage with a new or upgraded basin
Active removal when gravity drainage cannot keep up with hillside runoff or a high water table.
How the work typically runs
- 1
Load and outlet review
We estimate expected inflow, confirm discharge routing away from the foundation, and note power reliability for storm season.
- 2
Basin and pump sizing
Basin depth, pump capacity, and check valves are matched to the load - not a generic shelf unit guess.
- 3
Install and test
Equipment is installed, discharge is secured, and the system is tested under controlled water before we leave.
- 4
Backup discussion
Battery or secondary options are discussed for outages. Warranty and maintenance notes go in writing.
What influences cost
We do not publish fixed prices here. Access, wall length, soil, restoration, and discharge routing vary too widely on North Shore lots. These are the factors that usually shape an estimate:
- New basin versus pump-only swap
- Discharge length and outlet type
- Backup power requirements
- Integration with new interior drains
- Access for basin excavation indoors
Questions about sump pump systems
Why does my sump run all the time in the rain?
Heavy hillside inflow, short downspouts, failed footing drains, or a undersized pump can all cause it. We look upstream before assuming the motor alone is the fix.
Do you install battery backups?
When the scope calls for it. Backup options are discussed against outage risk and budget - not sold as a default upsell on every job.
Where should discharge go?
Away from the foundation and to an approved path. Dumping beside the wall defeats the system - we plan outlet location carefully.